Host Liberator - How to Clean Carpet (Liberator)

Vacuuming & Pile Lifting
Turn both machine brushes and vacuum switches ON.
4
How to Clean Carpet with the Liberator
Lawnmower Vacuuming
V
acuum in 2 directions.
Before Applying HOST Dry Carpet Cleaner
Place bucket on its side for 10 minutes. This will help
to distribute the liquid ingredients evenly throughout
the cleaner.
CAUTION: Nonhazardous per OSHA and EU standards when used as directed. Nontoxic via
ingestion, inhalation or skin absorption. Not a sensitizer. Not a skin or eye irritant. However,
persons with unusual skin sensitivity should protect skin from direct contact. In case of contact
with eyes, rinse with water to remove any particles. Improper use may contribute to increased
risk of health effects. NOT A WHMIS CONTROL PRODUCT.
Replacing Lid on Bucket
Be sure to wipe off the edge of bucket before replacing the lid.
This will prevent leaking.
1
Vacuum the area with the Liberator in 2 directions:
north/south and east/west. The more vacuuming
the better to remove as much dry dirt as possible.
a
In hallways and open areas,
vacuum lawnmower style in
2 directions: north/south
and east/west.
b
2
Filling the Applicator
Fill the Applicator with up to 12 pounds (5.4 kilos)
of HOST. Do not overfill!
3
4
Fill here
Hole cover
Fill port cover
Note: Standard (white) and firm (zebra) brushes must be broken in before using for the first time.
To break in brushes, run the Liberator on smooth concrete surface for 15 minutes.
Visit www.hostdry.com to
view Instructional Videos.
Tip