Hotpoint FF175BP - Page 15

CONTROL MODULE Parameters cont.
DEFROST AND DRIP TRAY HEATING ELEMENTS
Defrost and Drip Tray
Heating Elements -
The parameters utilised to start the
defrost cycle are as follows:
FREEZER FAN OPERATION
Freezer Fan Operation -
The freezer fan is managed by the
module and is switched on/off after a
preset time interval that is
parameterised in the module memory
after a compressor starUstop.
FRIDGE LAMP OPERATION
Fridge Lamp Operation -
The Interior lamps are controlled by a
triac and reed switch on the module .
1. Compressor ON time since the last defrost cycle.
720 minutes
2. Duration of doors open condition.
If the door is opened more than 60 minutes, there is a
defrost every 2 hours.
1. The defrost procedure is preceded by activation of the
fan for a timed interval that is parameterised in the
module memory.
4 minutes
2. After the defrost cycle the fan starts after a timed interval
following a compressor start, also this interval is
parameterised in the module memory;
5 minutes
NOTE:
This interval is different from the interval programmed for
normal operating conditions.
1. If the door remains open for a timed period that is
greater than the time interval stored in the module
memory, the lamp will start flashing and continue until
the door is closed.
2 minutes
15
VVPL00003242_0015