H.
Door Reversal - See Pages 20 and 21.
J. Damper (Baffle) Unit (Mechanical Type)
1.
Remove the Multi-Flow unit
as
in
G1
to
GS.
2.
Support the Multi-Flow unit
on
a flat protected surface with the fridge temperature control knob facing
upwards.
3.
Pull the control knob off the damper thermostat shaft.
NOTE: - When reassembling, ensure the phial from the damper thermostat
is
positioned into the
exhaust (return) duct.
K.
Freezer Fan Motor
1.
Remove the contents, food and furniture.
2.
Remove the screws from around the edge of the duct cover. (See photo 1.)
3.
Insert a slotted screwdriver into the cover upper vent holes to unclip the cover from the duct
assembly. (See photo 1.)
4.
Pull cover forward and withdraw. (See photo 2.)
5.
With the cover removed, unclip the duct assembly from the sides of the freezer liner and withdraw
assembly complete with fan motor housing. (See photo 3.)
6.
Disconnect fan wiring from the terminal block.
7.
Pull fan impeller off motor shaft, lay the duct assembly face down so the fan motor bracket
is
upper
most. Unclip the plastic fan motor bracket to release the fan motor.
Photo 1
-
0
Photo 3
~---..,..-----
Insert
a slotted screwdriver into the upper
-
19
vents to unclip it from the duct assembly
shown
in
Photo
3.
Photo 2
VVPL00003242_0019
To Next Page
Loading...
