EasyManua.ls Logo

Hotpoint RK960 - Self-Cleaning Oven Operation; Starting the Self-Cleaning Cycle

Hotpoint RK960
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
(Area seen through glass control
panel after knob is removed.)
The temperature on your new Oven
has been accurately set at the fac-
tory. However, if your food consist-
ently browns too much or too little,
you may make a simple adjustment
behind your Oven Temp Knob. To
readjust your thermostat:
@ Rotate OVEN TEMP Knob to
CLEAN position and pull knob off
the shaft revealing area behind
knob.
a.
Insert the tip of a 3/16” standard
-screwdriver, into the indented
area
directly under the notch and turn in
e desired direction. Be careful not
o scratch glass control panel.
@ To increase oven temperature
move dial one notch counter-
clockwise. To lower oven tempera-
ture, move dia! one notch
clockwise.
(Each notch represents approxi-
mately 15°.)
@ Return knob to the range by
matching the flat area of the knob
to the shaft.
@ Recheck oven performance
before making an additional
adjustment.
OvenVentDuct
The oven is vented through a duct
that’s located on the right side of
the oven just above the door handle
(see page 6). Moisture and vapors
from the oven are vented through it
when oven is in use. Nevercover
the hole in the duct. To do so pre-
vents it from functioning properly
during cooking and cleaning.
Lamp Replacement
CAUTION: Beforereplacingyour
ovenlamp bulb,disconnectthe
electricpowerfor yourCooking
Centerat the main
fuseorcircuit
breakerpanel.
Be sureto letthe
lampcoverandbulbcoolcom-
pletelybeforeremovingor
replacingthem.
To remove:
@Take out 3 slotted screws as
shown in lamp diagram.
@Detach lamp cover and remove
bulb.
To replace:
e+
put in a new 40-watt appliance
bulb.
~ Install lamp cover. Replace3
screws and tighten them, making
sure cover fits flush with oven wall.
@Reconnect electric power to the
Cooking Center.
Use of Aluminum Foil
in Broiling
/\
If you wish, you may line the broiler
pan with aluminum foil and cover
the rack with it for broiling. ALWAYS
BE SURE T@MOLD THE FOIL
THOROUGHLYTO THE BROILER
RACK AND SLIT THE FOIL TO
CONFORM WITH SLITS IN THE
RACK. Stopping fat and meat juices
from draining into the broiler pan
prevents the rack from serving its
purpose and MAY LET JUICES
BECOME HOT ENOUGH TO
CATCH FIRE.
Removable Oven Door
TO REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
TO REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
F
6%
pEJ
21