52 Chapter 9 D82008753R 10/15
Fault Code Lights
Speed Bars
When there is a fault please follow this procedure:
A. Switch off the control system.
B. Make sure that all connectors on the chair and
the control system are connected securely. Make
sure brake release levers are in the drive position.
C. Switch on the control system again and try to
drive the chair. If the fault occurs again, switch
off and do not try to use the chair. Contact
Hoveround
®
Technical Support 1-800-96-HOVER
(1-800-964-6837)
VSI Controller
new VSI Controller
Fault Code Lights
Speed Bars
Appendix B: Fault Codes
The microprocessor checks various features within the controller and will
display any fault indication. The controller may prevent the chair from
driving should a critical fault condition exist. Refer to the appropriate fault
code section for the system used on your MPV5
®
.
To Next Page
Loading...
