D82007778Q 09/15 Chapter 4 33
Locking the Seat Back
The seat back will fold forward when pushed from the rear or pulled from
the front (Figure 4J). If you prefer to have the seat back locked into
place and stationary; screws and a hex key have been provided with
your Hoveround to lock the seat back.
Figure 4J
Figure 4K Figure 4L Figure 4M
1. Locate the holes on each side of the seat back frame above the
angle adjustment hinge. (Figure 4K)
2. Insert the button head cap screws, one each side of the seat back.
Tighten with the 5/32" hex key. (Figures 4L and 4M)
To Next Page
Loading...
