38 Chapter 6 D82007778Q 09/15
Legrests
1. Install each legrest onto the appropriate hanger bracket and swing
into the forward facing position. If your chair has elevating legrests,
set the angle to the lowest position.
2. Fold down the foot plates. Your feet should comfortably rest on the
plates without a tendency to lift your thighs from the seat cushion.
3. If length adjustment is necessary, loosen the bolt at the base of one
of the legrest stems by two complete turns (1/2" wrench required).
Tap the head of the bolt to loosen the inner tube from the outer tube
(See Figure 6B below).
4. Slide the lower (inner) tube within the upper (outer) tube to achieve
the correct legrest length. Tighten the bolt.
5. Repeat steps 3 and 4 for other legrest.
Figure 6B - Legrest Adjustment
To Next Page
Loading...
