Speaker
A single speaker is located behind the front bezel. It is secured by bottom clips that fit into slots in the system
board. A WLAN antenna transceiver mounts to the front of the speaker assembly.
To remove the speaker:
1. Prepare the computer for disassembly (
Preparation for disassembly on page 17).
2. Remove the access panel (
Access panel on page 18).
3. From the inside of the computer, disconnect the speaker cable from the system board connector (1).
4. Disconnect the WLAN antenna cable that is secured to the speaker from the WLAN module connector
(2). The antenna that is secured to the speaker routes to the connector labeled ‘1’ on the WLAN module.
28 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
