HP 260 G1 - Computer Setup (F10) Utility; Computer Setup (F10) Utilities

System board
NOTE: All system board spare part kits include replacement thermal material.
NOTE: System board appearance may vary.
Description
System board with embedded Intel Core i5-4210U processor:
●
Without Windows operating system
●
Windows 8.1 Standard
●
Windows 8.1 Professional
●
NetClone
System board with embedded Intel Core i3-4030U processor:
●
Without Windows operating system
●
Windows 8.1 Standard
●
Windows 8.1 Professional
●
NetClone
System board with embedded Intel Pentium 3558U processor:
●
Without Windows operating system
●
Windows 8.1 Standard
●
Windows 8.1 Professional
●
NetClone
System board with embedded Intel Celeron 2957U processor:
●
Without Windows operating system
●
Windows 8.1 Standard
●
Windows 8.1 Professional
●
NetClone
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (
Access panel on page 18).
3. Remove the memory modules (
Memory on page 21).
4. Remove the hard drive (
Hard drive on page 19).
5. Remove the drive cage (
Drive cage and drive cable on page 32).
6. Remove the WLAN module (
WLAN module on page 35).
7. Remove the solid-state drive (if installed) (
M.2 solid-state drive on page 37).
8. Remove the fan (
Fan on page 30).
9. Remove the heat sink (
Heat sink on page 31).
System board 39