What to do if HP 3000 9X9/KS shows 'POWER FAIL' error?
If your HP Server displays a 'POWER FAIL' message, it indicates that AC power is either unavailable or out of specification. First, examine the power source. If the issue persists, consider replacing the PM card or the power supply.
What to do if HP 3000 9X9/KS displays 'DC OVERVOLTAGE' error?
If your HP Server shows a 'DC OVERVOLTAGE' error, it means an overvoltage condition was detected on the specified D.C. voltage (+X.Y). To resolve this, you can try replacing the power supply or replacing the PM card.
What to do if HP Server displays 'DC UNDERVOLTAGE' error?
If your HP Server displays a 'DC UNDERVOLTAGE' error, it indicates an undervoltage condition on the specified D.C. voltage (+X.Y). The suggested solutions are to replace the power supply or replace the PM card.
How to fix HP 3000 9X9/KS with no front panel display but the system is operating?
If your HP Server system is operating but there is no front panel display, the following steps are suggested: 1. If the operating system is running without issues, shut it down. 2. Check the internal cables connecting the power monitor to the front panel. 3. Replace the front panel. 4. Replace the power monitor card. 5. Replace the system board.
What causes 'PM POWER ERROR' on HP 3000 9X9/KS Server and how to fix it?
If your HP Server displays a 'PM POWER ERROR', it indicates that the +15V is not within specifications. To resolve this, you can try replacing the power supply or replacing the PM card.
What causes 'FRONT FAN POWER SHUTDOWN' on HP 3000 9X9/KS Server?
If you receive a 'FRONT FAN POWER SHUTDOWN' error on your HP Server, it means the front fan is either dead or running too slowly. Try replacing the front fan, replacing the PM card, or replacing the fan cables.
Why does my HP 3000 9X9/KS Server show 'REAR FAN POWER SHUTDOWN'?
If your HP Server displays 'REAR FAN POWER SHUTDOWN', this means the rear fan is either not working or running too slow. To fix this, you can replace the rear fan, replace the PM card, or replace the fan cables.
What to do if HP Server backlight is on but display panel is blank?
If the backlight is on but the display panel is blank on your HP Server, it suggests the display panel data is dim. You can try replacing the PM card, replacing the display panel, or replacing the ribbon cable.
Why does my HP Server show 'SWITCH ON' error?
If your HP Server displays 'SWITCH ON', it indicates a bad power supply fan. You can try replacing the power supply fan or replacing the power supply.
To Next Page
General