Installing
Digita-l
Extender
Cables
Installing the
HP
3235
26
S T R A I N
--:;-,--->-
RELIEF
CLAMP
Figure
16.
Analog Extender Cable Strain Relief.
j.
If
you are rack mounting the frames. install the extender modules
after
rack mounting. Install
the
extender modules
as
described in the section
'1nsta1ling a Bus Access (or Extender Mocluiet
in
this manual.
The
digital extender cable
is
the communication link between mainframe and ex-
tender,
Two
connectors on the extender module are present
for
instaJling the
digital extender cable.
The
connectors are bi-directional
and
the
cable
can
be at-
tached
to
either connector.
The
maximum cumulative length
for
the
digital ex-
tender cable
is
10
metres (see Figure
12).
A digital extender cable
is
supplied in a
stant.lard length
of
I metre. Option 570 replaces the 1 metre cable with a 3
metre cable. The steps required
to
install a digital extender cable follow.
a.
If
rack mounting the frames, install the cable after the frames are mount-
ed. Extender modules. with analog extender cables, should be installed.
The
system-side panel, containing the silkscreening, should also be in place.
b.
Install the digital
extender
cable
to
either connector beneath the
EXTENDER label. One end
to
the mainframe and
one
end
to
the
extender
frame.
If
more than
one
extender
is
in
the system,
connect
the
second cable
from the first extender
to
the
second extender, etc. See Figure
12.
b.
Secure the connectors by tightening the screws
on
each end
of
the
connector.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General