HP 33120A - SCPI Command Summary

SCPI Command Summary
This section summarizes the SCPI (Standard Commands for
Programmable Instruments) commands available to program the
Phase-Lock assembly over the remote interface. If you are a first-time
user of the
SCPI language, refer to “An Introduction to the SCPI
Language,” starting on page 211 in the HP 33120A User’s Guide.
Throughout this manual, the following conventions are used for
SCPI command syntax.
• Square brackets ( [ ] ) indicate optional keywords or parameters.
• Braces ( { } ) enclose parameters within a command string.
• Triangle brackets ( < > ) indicate that you must substitute a value
for the enclosed parameter.
• A vertical bar (
|
) separates multiple parameter choices.
Phase-Lock Commands (Option 001)
(see page 18 and 19 for more information)
PHASe:ADJust {<radians>|MINimum|MAXimum}
PHASe:ADJust?
PHASe:REFerence
PHASe:UNLock:ERRor:STATe {OFF|ON}
PHASe:UNLock:ERRor:STATe?
OUTPut:TRIGger:IMMediate
OUTPut:TRIGger:STATe {OFF|ON}
OUTPut:TRIGger:STATe?
*OPT?
2
Chapter 2 Remote Interface Operation
SCPI Command Summary
17