To Phase Lock Using the Triggered Burst Mode
In the triggered burst mode, you can synchronize phase-lock signals
using an external trigger from the rear-panel Ext Trig terminal.
The following statements show you how to synchronize two function
generators in the triggered burst mode (send the commands to both
function generators):
"APPL:SIN 10E+3, 5.0" Set both to the same frequency
"BM:NCYC INF" Set burst count to “
INFINITY”
"BM:STAT ON" Enable the burst mode
"TRIG:SOUR EXT" Set trigger source to external
Send the following command statement to only one function generator:
"OUTP:TRIG:IMM" Issue external trigger to all instruments
Chapter 2 Remote Interface Operation
Simplified Programming Overview
22
To Next Page
Loading...
