9. If it is necessary to remove the display hinges:
a. Remove the Phillips M2.0 × 2.5 screw (1) from the bottom of each hinge.
b. Remove the two Phillips M2.5 × 2.5 screws (2) from the bottom of each hinge.
c. Remove the Phillips M2.5 × 3.0 screw (2) from the top of each hinge.
d. Remove the display hinges from the display back cover (4).
The display hinges are available as spare part number L64910-001.
10. If it is necessary to remove the display panel cable:
a. Remove the cable from the channel at the bottom of the display back cover (1).
b. Remove the cable from the bottom (2) and top (3) of the display back cover.
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
