To Set the Baud Rate
You can select one of six baud rates for RS-232 operation. The rate is set
to 9600 baud when the multimeter is shipped from the factory. See also
“Baud Rate Selection,” on page 93.
1 Turn on the front-panel menu.
A: MEAS MENU
2 Move across to the
I/O MENU choice on this level.
E: I/O MENU
3 Move down a level and then across to the
BAUD RATE command.
3: BAUD RATE
4 Move down to the “parameter” level to select the baud rate.
Use the left/right arrow keys to see the baud rate choices. Choose from
one of the following: 300, 600, 1200, 2400, 4800, or 9600 baud.
9600 BAUD
5 Save the change and exit the menu.
The baud rate selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
∨
<
<
Shift <
On/Off
Auto/Man
ENTER
∨
>
>
4
Chapter 4 Remote Interface Reference
To Set the Baud Rate
163
To Next Page
Loading...
