HP 34401A - SCPI Compliance Information

SCPI Compliance Information
The following commands are device-specific to the HP 34401A. They are
not included in the 1991.0 version of the
SCPI standard. However, these
commands are designed with the
SCPI format in mind and they follow
all of the syntax rules of the standard.
Many of the required SCPI commands are accepted by the multimeter
but are not described in this manual for simplicity or clarity. Most of
these non-documented commands duplicate the functionality of a
command already described in this chapter.
MEASure
:CONTinuity?
:DIODe?
SAMPle
:COUNt {<
value>|MINimum|MAXimum}
:COUNt? [MINimum|MAXimum]
[SENSe:]
FUNCtion "CONTinuity"
FUNCtion "DIODe"
FREQuency:VOLTage:RANGe {<
range>|MINimum|MAXimum}
FREQuency:VOLTage:RANGe? [MINimum|MAXimum]
FREQuency:VOLTage:RANGe:AUTO {OFF|ON}
FREQuency:VOLTage:RANGe:AUTO?
PERiod:VOLTage:RANGe {<
range>|MINimum|MAXimum}
PERiod:VOLTage:RANGe? [MINimum|MAXimum]
PERiod:VOLTage:RANGe:AUTO {OFF|ON}
PERiod:VOLTage:RANGe:AUTO?
ZERO:AUTO?
SYSTem
:LOCal
:REMote
:RWLock
CALCulate
:AVERage:MINimum?
:AVERage:MAXimum?
:AVERage:AVERage?
:AVERage:COUNt?
:DB:REFerence {<
value>|MINimum|MAXimum}
:DB:REFerence? [MINimum|MAXimum]
:DBM:REFerence {<
value>|MINimum|MAXimum}
:DBM:REFerence? [MINimum|MAXimum]
:FUNCtion {NULL|DB|DBM|AVERage|LIMit}
:FUNCtion?
:LIMit:LOWer {<
value>|MINimum|MAXimum}
:LIMit:LOWer? [MINimum|MAXimum]
:LIMit:UPPer {<
value>|MINimum|MAXimum}
:LIMit:UPPer? [MINimum|MAXimum]
:NULL:OFFSet {<
value>|MINimum|MAXimum}
:NULL:OFFSet? [MINimum|MAXimum]
CALibration
:COUNt?
:SECure:CODE <
new code>
:SECure:STATe {OFF|ON},<
code>
:SECure:STATe?
:STRing <
quoted string>
:STRing?
CONFigure
:CONTinuity
:DIODe
INPut
:IMPedance:AUTO {OFF|ON}
:IMPedance:AUTO?
Chapter 4 Remote Interface Reference
SCPI Compliance Information
168