4 Move across to the BEEP command on the “commands” level.
There are eight command choices available in the
SYS MENU. Each
choice on this level has a number prefix for easy identification (
1: , 2: , etc.).
6: BEEP
5 Move down a level to the
BEEP parameter choices.
The first parameter choice is “
ON” for the BEEP command (the beeper
setting is stored in non-volatile memory and “
ON” is the factory setting).
ON
6 Move across to the
“OFF” choice.
There are two parameter choices for
BEEP.
OFF
7 Save the change and turn off the menu.
The multimeter beeps and displays a message to show that the change
is now in effect. You are then exited from the menu.
CHANGE SAVED
>
Auto/Man
ENTER
∨
> > >
> >
Chapter 2 Front-Panel Menu Operation
A Front-Panel Menu Tutorial
32
To Next Page
Loading...
