HP 34970A - Page 182

Scan Configuration Commands
(see page 226 for more information)
ROUTe
:SCAN (@<scan_list>)
:SCAN?
:SCAN:SIZE?
TRIGger
:SOURce {BUS|IMMediate|EXTernal|ALARm1|ALARm2|ALARm3|ALARm4|TIMer}
:SOURce?
TRIGger
:TIMer {<
seconds>|MIN|MAX}
:TIMer?
TRIGger
:COUNt {<
count>|MIN|MAX|INFinity}
:COUNt?
ROUTe
:CHANnel:DELay <
seconds>[,(@<ch_ list>)]
:CHANnel:DELay? [(
@<ch_list>)]
:CHANnel:DELay:AUTO {OFF|
ON}[,(@<ch_list>)]
:CHANnel:DELay:AUTO? [(
@<ch_list>)]
FORMat
:READing:ALARm {
OFF|ON}
:READing:ALARm?
:READing:CHANnel {
OFF|ON}
:READing:CHANnel?
:READing:TIME {
OFF|ON}
:READing:TIME?
:READing:UNIT {
OFF|ON}
:READing:UNIT?
FORMat
:READing:TIME:TYPE {ABSolute|RELative}
:READing:TIME:TYPE?
ABORt
INITiate
READ?
This command redefines the scan list when executed.
This command applies to all channels in the instrument (Global setting).
Default parameters are shown in bold.
Chapter 5 Remote Interface Reference
SCPI Command Summary
184