HP 34970A

Scan Measurement Commands
(see page 226 for more information)
MEASure
:TEMPerature? {TCouple|RTD|FRTD|THERmistor|DEF}
,{<
type>|DEF}[,1[,{<resolution>|MIN|MAX|DEF}]] ,(@<scan_list>)
:VOLTage:DC? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:VOLTage:AC? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:RESistance? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:FRESistance? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:CURRent:DC? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:CURRent:AC? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:FREQuency? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:PERiod? [{<
range>|AUTO|MIN|MAX|DEF}
[,<
resolution>|MIN|MAX|DEF}],] (@<scan_list>)
:DIGital:BYTE? (
@<scan_list>)
:TOTalize? {
READ|RRESet} ,(@<scan_list>)
Monitor Commands
(see page 237 for more information)
ROUTe
:MONitor (
@<channel>)
:MONitor?
ROUTe
:MONitor:STATe {
OFF|ON}
:MONitor:STATe?
ROUTe:MONitor:DATA?
This command redefines the scan list when executed.
Default parameters are shown in bold.
5
Chapter 5 Remote Interface Reference
SCPI Command Summary
183