You can configure the event or action that controls the onset of each
sweep through the scan list (a sweep is one pass through the scan list):
• You can set the instrument’s internal timer to automatically scan at
a specific interval as shown below. You can also program a time delay
between channels in the scan list.
• You can manually control a scan by repeatedly pressing from
the front panel.
• You can start a scan by sending a software command from the
remote interface.
• You can start a scan when an external
TTL trigger pulse is received.
• You can start a scan when an alarm condition is logged on the
channel being monitored.
Scan List (1 sweep)
t
Scan-to-Scan Interval
(0 to 99:59:59 hours)
Scan Count
(1 to 50,000 scans, or continuous)
3
Chapter 3 System Overview
Measurement Input
63
To Next Page
Loading...
Need help?
General