HP 4110 - Connecting (Desktop Use)

HP 4110 Quick Start Guide
5
E
N
G
L
I
S
H
Connecting (Desktop Use)
1. Attach the phone cord (Step 1), then slide the phone into the
phone stand (Step 2).
1.
2.
2. Connect the Ethernet cable into the NET port (left-most
port).
Note: The phone is a PoE phone. If you are not using PoE,
also connect an HP 5V power supply. Caution: A 48V supply, as
used by other IP phone vendors, will permanently disable this phone.
Use only a Hewlett-Packard (HP) 5V external power supply (J9767A)
.
.
NET PC
If no PoE
available
5V DC