Model 5328A
Operation
1.
FUNCTION switch
0.
Functions which use the DVM are:
a.
DVM. Measures the voltage at the DVM terminals for a period of time determined by
the setting of the RESOLUTION,
N
switch:
N
MEASUREMENT TIME
1
*b.
NaDVM/A. Scales voltage at the DVM terminals by the factorfreqwherefreq A 510
MHz. N selects the number
of
events at A over which the measurement
is
made.
**c. DVM, A--B.
Integrates voltage at the DVM terminals over the synchronized time
interval defined by events at channels A and B. Units of the displayed reading are
volt.seconds.
*"phantomn function.
2
switch positions clockwise from STOP.
**"phantom" function.
3
switch positions clockwise from STOP.
2.
DCV RANGE switch
a.
Permits selection of 210V, tIOOV, k1000V range or AUTORANGE.
3.
FILTER switch
@.
When on, allows measuring small signals in the presence of high common
mode noise. Response time when on is 1 second, when OFF, 10 ms.
4.
HI input terminal. Input terminal for high potential of external voltage. Must be less than
1100 volts above LO input terminal.
5. LO input terminal. Input terminal for low potential of external voltage. Must be less than 500
volts above chassis ground.
Figure 3-73. Model5328A Option 027, High Performance DVM Front PanelOperationSummary
3-1
7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
