HP 9000 rp4440 - Page 40

Chapter 3
Upgrade Procedures for 1.1 GHz mx2 Dual Processor Modules (A9730A)
Introduction
40
Step 4. Plug in the processor cable to its socket on the extender board.
Step 5. Place the sequencer frame over the processor.
Step 6. Using the CPU install tool, tighten the T15 shoulder screws 1, 2, 3, and 4 until they just bottom out.
Follow the tightening sequence shown in Figure 3-3, “Installing Processor on Extender Board.”