HP 9000 rp4440 - Enabling the Onboard VGA; Figure 3-5 IO Baseboard Select Switches

Chapter 3
Upgrade Procedures for 1.1 GHz mx2 Dual Processor Modules (A9730A)
Introduction
44
Enabling the Onboard VGA
To enable the onboard VGA, perform the following steps:
Step 1. On the IO baseboard, set the VGA Select Switch on as shown in Figure 3-5, “IO Baseboard Select
Switches.”
Figure 3-5 IO Baseboard Select Switches
CPU Select
VGA Select