B-2 Error Messages
F:?
?D
....,
.-
.. !
{ .
.::)
7
:::~
f::
1
Description
.
Excessive rejected tracks during a mass storage initialization. The medium
can't
be
initialized.
If
the medium is a flexible disk, use a different one.
If
the medium
is a hard disc, call your HP Sales and Service
Office for assistance, to determine
whether there has
been
a hardware failure.
Mass storage parameter less than or equal to
O.
Check values of variables.
Record numbers, record lengths
and
number
of defined records must
be
posi-
tive numbers.
Invalid line number in
C;
E::
T·
or L I
'·····1
r·::::
operation. Check line numbers. May
be
trying to
LINK
to
file
that
doesn't
contain a program.
Format switch
on
the disc off. Turn it on.
Not a disc interface. Check mass storage unit specifier.
Disc interface power off. Turn it on.
Incorrect controller address, controller power off, or disc time out. Check mass
storage unit specifier; make sure controller is on .
Incorrect device type in mass storage unit specifier.
Drive misSing or power off.
Disc system error, type
P.
Incorrect unit code in mass storage unit specifier.
Disc system error, type IF.
Unused.
Unused.
Cartridge
out
or
door
open. Also check to
see
if
interface
is
connected prop-
erly.
Mass storage device failure. Possible power failure.
Mass storage device
not
present. Check mass storage unit specifier.
Write protected. Check the write-protection device
on
the medium or drive.
Record not found. There
is
a
bad
spot
on
the medium.
mass storage medium is
not
initialized.
Not a compatible tape cartridge.
Record address error; information
can't
be
read. Hardware failure. Check for a
dirty read
~ead.
Read data error. Hardware failure. Check for a dirty read head.
Check read error.
Mass storage system error.
1
See
the
Mass Storage Techniques Manual.
To Next Page
Loading...
