HP A5820X Series Configuration Guide

16
Configuring global load sharing criteria
To configure the global IRF link load sharing criteria:
To do… Use the command… Remarks
1. Enter system view
system-view —
2. Configure the global IRF
link load sharing criteria
irf-port load-sharing mode {
destination-ip | destination-mac |
source-ip | source-mac } *
Required.
By default:
• The A5800-48G Switch with 1
Interface Slot (JC105A), A5800-
48G TAA Switch with 1 Interface
Slot (JG258A), A5800-48G-PoE+
Switch with 1 Interface Slot
(JC104A), and A5800-48G-PoE+
TAA Switch with 1 Interface Slot
(JG257A) base load sharing
calculation on the incoming port
number.
• Other models in the A5800 and
A5820X series use the
combination of the source and
destination MAC addresses as the
load sharing criteria for Layer 2
packets, and the combination of
the source and destination IP
addresses for Layer 3 packets.
Configuring port-specific load sharing criteria
To configure the port-specific load sharing criteria:
To do… Use the command… Remarks
1. Enter system view
system-view —
2. Enter IRF port view
irf-port
member-id
/
port-number
—

HP A5820X Series Specifications

General

Brand	HP
Model	A5820X Series
Category	Switch
Language	English