HP ac300w - Looping Video Mode

33
Looping video mode
• The loop video function is only applicable when the video
resolution is set to 1080p30.
• Multiple small segments are written to the memory card,
and these segments will be overwritten during loop
recording.
• Without any looping files, the system will indicate that the
card is full when the remaining storage is less than
800MB.
• The looping video will perform when the remaining
storage and saved looping files capacity are more than
800MB.
• When looping video mode is enabled, you can do the
following operations in SET menu:
Disable the looping video mode, enable/disable the
upside down function, delete the all looping files.
• When you perform the Delete All operation, only the
looping files will be deleted.
• When the loop recording is enabled the auto power off
time will depend on the Auto Power Off setting. For
example, the Auto Power Off is set to 10 minutes, the
camera will automatically power off after being idle for 10
minutes.
• If you power on the camera manually, you need to start
and stop the video recording manually too.