HP b2600 Technical Reference

Chapter 4 111
Boot Console Handler
Displaying and Setting the Monitor Type
Displaying and Setting the Monitor Type
The workstation ships from the factory preset to use a monitor with a specific resolution
and frequency. If the workstation’s monitor is replaced with a different type of monitor, you
may have to reconfigure the workstation to support the new monitor.
The Monitor Command
The monitor command lets you change the workstation’s graphics configuration. This
command is available in the Configuration Menu of the Boot Console Handler.
NOTE The monitor command lets you change a workstation’s graphics
configuration before you replace the monitor. For information about changing
the configuration after you replace the monitor, go to the section “Setting the
Monitor Type at Power On” found in this chapter.
To display the current graphics and console information, type the following set of
commands:
Main Menu: Enter command > configuration [Enter]
Configuration Menu: Enter command > monitor [Enter]
The correct usage for setting the graphics configuration is:
Configuration Menu: Enter command > monitor graphics_path type [Enter]
where valid graphics_path parameters are:
•
graphics(1) - Graphics adapter installed in slot 1
•
graphics(2) - Graphics adapter installed in slot 2
•
graphics(3) - Graphics adapter installed in slot 3
•
graphics(4) - Graphics adapter installed in slot 4
NOTE No blanks or spaces may be used in the graphics_path .
type is the numerical monitor type as shown with the monitor list command. See the
section “Setting the Monitor Type” found in this chapter for a list of types. For example, a
graphics card installed in option slot 1 would be
graphics(1) .

HP b2600 Specifications

General

Brand	HP
Model	b2600
Category	Desktop
Language	English