Appendix C 163
HP B2600 Chassis Codes
Chassis Codes
TST C680 SYS BD builtin graphics Look for built-in graphics card.
TST C68s SYS BD test graph in
s
Look for graphics card in PCI slot s.
INI C68s SYS BD init graph in s Successfully initialized graphics card in
PCI slot s.
INI C68
0
SYS BD bultin graphics Successfully initialized built-in graphics
card.
WRN C68
0
SYS BD bultin graphics built-in graphics initialization failed.
WRN C68s SYS BD fail graph in
s
Card in PCI slot s failed graphics
initialization or is not a graphics card.
INI C740 EXT IO init other path Autoboot is trying to boot from
non-primary boot device.
INI C780 EXT IO ld IPL othr path Loading IPL from non-primary boot
device.
WRN C7F0 EXT IO other IPL fault Error loading IPL from non-primary boot
device.
WRN C7F1 EXT IO bad alt IPL read Cannot load IPL from non-primary boot
device--load address invalid.
WRN C7F2 EXT IO bad alt IPL read Cannot load IPL from non-primary boot
device--file is not IPL image.
WRN C7F3 EXT IO bad alt IPL read Cannot load IPL from non-primary boot
device--IPL image size invalid.
WRN C7F4 EXT IO bad alt IPL read Cannot load IPL from non-primary boot
device--IPL entry point address invalid.
WRN C7F8 EXT IO bad alt IPL read Cannot load IPL from non-primary boot
device--IPL image checksum failed.
WRN C7FF <blank> launch IPL other Booting from a device other than the
primary boot path.
INI CB00 SYS BD TOC initiated A Transfer of Control entered the
firmware TOC handler.
WRN CB01 SYS BD no OS TOC vector There is no TOC vector for the operating
system. Firmware will soft boot the
system.
WRN CB02 SYS BD bad OS TOC addr The operating system TOC handler vector
is invalid. Firmware will soft boot the
system.
Table C-1. Chassis Codes for B2600 Workstations
Ostat Code FRU Message Description
To Next Page
Loading...
Need help?
General