HP b2600 Technical Reference

168 Appendix C
HP B2600 Chassis Codes
Chassis Codes
FLT CBFE SYS BD HPMC during TOC A High-Priority Machine Check occurred
during Transfer of Control processing.
FLT CBFF SYS BD multiple HPMCs A High-Priority Machine Check occurred
while processing another HPMC.
INI CC0n SYS BD CPU n OS rendezvs Slave CPU n entering the final
rendezvous, waiting for the operating
system to awaken it.
INI CC1n SYS BD CPU n early rend Slave CPU n entering the early
rendezvous, waiting for the monarch CPU
to initialize scratch RAM and other
system state.
INI CC2n SYS BD CPU n rendezvous Slave CPU n entering rendezvous. Slave
CPUs enter this rendezvous numerous
times during boot.
INI CC3n SYS BD CPU n cache rend Slave CPU n entering cached rendezvous,
waiting for the monarch CPU to configure
the system bus.
INI CC4n SYS BD CPU n mem rendez Slave CPU n entering memory
rendezvous, waiting for the monarch CPU
to select a boot device.
TST D000 SYS BD micro controller Firmware is initializing communications
with the system controller.
WRN D004 SYS BD micro not resp Firmware detected a communications
error with the system controller.
INI D005 SYS BD set dom1 fan spd Firmware is initializing communications
with the system controller.
INI D006 SYS BD set dom2 fan spd Firmware is initializing communications
with the system controller.
WRN D007 SYS BD bad microctl cmd Firmware detected a communications
error with the system controller.
FLT D01n SYS BD fan n : failure! Firmware detected system fan n stopped.
To determine the values for n, see the
section “Removing Fan Modules” in
Chapter 3.
WRN D02n SYS BD fan n : too slow! Firmware detected system fan n is
running too slowly. To determine the
values for n, see the section “Removing
Fan Modules” in Chapter 3.
Table C-1. Chassis Codes for B2600 Workstations
Ostat Code FRU Message Description

HP b2600 Specifications

General

Brand	HP
Model	b2600
Category	Desktop
Language	English