Accessing Internal Components
49
Accessing Internal Components
Removing and Replacing the Main Cover
WARNING
For your safety, disconnect the power cord and all external cables.
To Remove the Main Cover
1 Place the PC on a flat surface and stand behind it.
2 Disconnect all cables from the rear of the PC.
3 Loosen the two thumb screws at the rear of the PC.
4 Slide the cover back by about 2 cm (0.6 inches).
5 Tip the cover to the side and lift it off.
To Replace the Main Cover
1 Position the metal flap on the bottom inside of the cover over the guide
rail of the PC, leaving a gap of about 2 cm (0.6 inches) between the
cover and the front of the PC.
2 Tilt the cover towards the PC.
To Next Page
Loading...
