12. If it is necessary to replace the display back cover:
a. Remove the six Phillips M2.5 × 3.0 broadhead screws (1) that secure the back cover to the display
hinges.
b. Remove the back cover (2).
c. Note the routing of the cables near the left hinge (3).
NOTE: The back cover is available using spare part numbers L14908-001 (in chalkboard gray
nish) and L14911-001 (in delicate orange nish), and includes the webcam/microphone module
cable and wireless antennas and cables.
13. If it is necessary to replace the display panel cable:
Component replacement procedures 45
To Next Page
Loading...
