b. Remove the display bracket (2).
The display bracket is available using spare part number L89774-001.
4. Remove the display panel by following these steps:
a. Remove the four Phillips M2.0×2.9 screws (1) that secure the display panel to the display back cover.
b. Swing the top edge (2) of the display panel up and forward until it rests upside down on the computer.
c. Release the adhesive support strip (1) that secures the display panel cable connector to
the display panel.
d. Disconnect the display panel cable (2) from the display panel.
46 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
