Battery
Description Spare part number
Battery (4-cell, 48 WHr, 3.2 AH, Li-ion) 941617-855
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
Before removing the battery, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the display panel (see Display panel assembly on page 20).
Remove the battery:
1. Release the adhesive cover from the battery (1).
CAUTION: To avoid damaging the system board, remove the adhesive cover only from the battery.
2. Release the battery cable from the system board (2).
3. Remove the ve Phillips M2.0 × 3.0 screws (3) that secure the battery to the base enclosure.
4. Remove the battery from the base enclosure (4).
Reverse this procedure to install the battery.
24 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
