Reverse this procedure to install the power button board.
Right speaker
Description Spare part number
speaker, right xxxxxx-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
Before removing the right speaker, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the display panel (see Display panel assembly on page 20), and then remove the following
components:
▲
Battery (see Battery on page 24).
Remove the right speaker:
1. Release the speaker cable from the USB board (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2) that secure the speaker to the base enclosure.
3. Remove the speaker(3).
4. Detach and replace the volume button board and volume button board cable from the right speaker (1)
before completely removing the speaker from the computer.
Component replacement procedures 27
To Next Page
Loading...
