Front webcam
NOTE: The front webcam spare part kit includes the webcam cable.
Description Spare part number
Front webcam xxxxxx-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement..
Before removing the front webcam, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the display panel (see Display panel assembly on page 20), and then remove the following
component:
▲
Battery (see Battery on page 24).
Remove the front webcam:
1. Release the front webcam cable from the ZIF connector attaching it to the system board (1).
2. Remove the front webcam cable from the base enclosure (2).
3. Remove the front webcam from the base enclosure (3).
Reverse this procedure to install the front webcam.
Component replacement procedures 33
To Next Page
Loading...
