POGO board
NOTE: The POGO board spare part kit includes the POGO board cable.
Description Spare part number
POGO board L17081-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement..
Before removing the POGO board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the display panel (see Display panel assembly on page 20), and then remove the following
component:
▲
Battery (see Battery on page 24).
Remove the POGO board:
1. Release the POGO board cable from the ZIF connector on the system board (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2) that secure the POGO board to the base enclosure.
3. Remove the POGO board cable from the base enclosure (3).
4. Remove the POGO board from the base enclosure (4).
Reverse this procedure to install the POGO board.
32 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
