WLAN antenna
Description Spare part number
WLAN dual antenna module L17064-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
Before removing the WLAN antenna module, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the display panel (see Display panel assembly on page 20), and then remove the following
components:
▲
Battery (see Battery on page 24).
Remove the WLAN antenna module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
2. Remove the four Phillips M2.0 × 3.0 screw (2) that secure the antennas to the base enclosure.
3. Remove the antennas from the base enclosure (3).
Reverse this procedure to install the WLAN antenna module.
Component replacement procedures 35
To Next Page
Loading...
