a. Remove the display bezel.
b. Remove the display panel.
c. Remove the two Phillips M2.0 × 2.8 screws (1) that secure the hinge brackets to the display back
cover.
d. Remove the six Phillips M2.5 × 2.9 broad head screws (2) that secure the hinges to the display back
cover.
e. Remove the display hinges (3).
The display hinges are available using spare part number M15311-001.
15. If you need to replace the display hinge covers:
a. Remove the display bezel.
b. Remove the display panel.
c. Remove the display hinges.
d. Loosen the two captive Phillips screws (1) that secure the hinge covers to the display hinges.
ENWW Component replacement procedures 43
To Next Page
Loading...
