9
Backup and recovery in
Windows XP
Creating recovery discs
After setting up the computer for the first time, be sure to create a set of recovery discs of the full factory
image. The recovery discs are used to start up (boot) the computer and recover the operating system and
software to factory settings in case of system instability or failure.
Note the following guidelines before creating recovery discs:
●
You will need high-quality CD-R, DVD-R, or DVD+R discs (purchased separately).
NOTE: Read-write discs, such as CD-RW and DVD±RW discs, are not compatible with HP Backup
and Recovery Manager.
●
The computer must be connected to AC power during the process.
●
Only one set of the recovery discs can be created per computer.
●
Number each disc before inserting it into the optical drive of the computer.
●
If necessary, you can cancel the disc creation before you have finished creating the recovery discs.
The next time you select Create factory software recovery CDs or DVDs to recover the
system (Highly recommended), you will be prompted to continue the disc creation.
To create a set of recovery discs:
1. Select Start > All Programs > HP Backup & Recovery > HP Backup and Recovery
Manager.
2. Click Next.
3. Click Create factory software recovery CDs or DVDs to recover the system (Highly
recommended), and then click Next.
4.
Follow the on-screen instructions.
Creating recovery discs 135
To Next Page
Loading...
Need help?
General
Weight and Dimensions
