MultiBay II device
Description Spare part number
DVD±RW and CD-RW Super Multi Double-Layer Combo Drive 446409-001
DVD/CD-RW Combo Drive 446410-001
DVD-ROM Drive 446408-001
Before removing the MultiBay II device, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4.
Remove the battery (see
Battery on page 42).
Remove the optical drive:
1.
Position the computer with the left side toward you.
2. If present, remove the Phillips PM2.5×5.0 screw (1) that secures the MultiBay II device to the
computer.
3. Push in on the right side of the MultiBay II device (2). (The MultiBay II device partially ejects from
the MultiBay II.)
4. Remove the MultiBay II device (3) from the computer.
Reverse this procedure to install a MultiBay II device.
56 Chapter 4 Removal and replacement procedures