EasyManuals Logo

HP COMPAQ DC5750 User Manual

HP COMPAQ DC5750
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #193 background imageLoading...
Page #193 background image
Service Reference Guide, dc5750 437963-001 D–27
Troubleshooting Without Diagnostics
Network controller stops
working without apparent
cause.
(continued)
The network controller is
defective.
Replace the system board.
New network card will
not boot.
New network card may be
defective or may not meet
industry-standard
specifications.
Install a working, industry-standard
NIC, or change the boot sequence
to boot from another source.
Cannot connect to
network server when
attempting Remote
System Installation.
The network controller is
not configured properly.
Verify Network Connectivity, that a
DHCP Server is present, and that
the Remote System Installation
Server contains the NIC drivers for
your NIC.
System setup utility
reports unprogrammed
EEPROM.
Unprogrammed EEPROM. Flash the ROM.
Solving Network Problems (Continued)
Problem Cause Solution

Table of Contents

Other manuals for HP COMPAQ DC5750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP COMPAQ DC5750 and is the answer not in the manual?

HP COMPAQ DC5750 Specifications

General IconGeneral
Processor SpeedUp to 2.8 GHz
ChipsetATI Radeon Xpress 1150
MemoryUp to 4 GB DDR2 SDRAM
AudioIntegrated High Definition Audio
NetworkIntegrated Broadcom NetXtreme Gigabit Ethernet
ProcessorAMD Athlon 64 X2 / AMD Sempron
StorageSATA Hard Drive
Optical DriveDVD-ROM, DVD+/-RW
Operating SystemWindows XP Professional
Form FactorSmall Form Factor or Microtower
USB Ports8 USB 2.0 (2 front, 4 rear, 2 internal)

Related product manuals