HP Compaq dc7600 MT Technical Reference Guide

6-4 www.hp.com Technical Reference Guide
Integrated Graphics Subsystem
For viewing the maximum amount of available frame buffer memory MS Windows 2000 or XP,
go to Display Properties > Settings> Adapter.
The Microsoft Direct diagnostic tool included in most versions of Windows may be used to
check the amount of video memory being used. The Display tab of the utility the “Approx. Total
Memory” label will indicate the amount of video memory. The value will vary according to OS
(Windows 98 will typically show 0.5 to 5 MB or higher, depending on screen resolution and
application. In Windows 2000 or XP, the video memory size reported by DirectX will always be
32 MB, even if the total memory installed is over 128 MB.
✎
Some applications, particularly games that require advanced 3D hardware acceleration, may not
install or run correectly on systems using the IGC.
6.3 Display Modes
The IGC supports most standard display modes for 2D video displays up to and including 2048 x
1536 @ 85 Hz , and 3D display modes up to 1600 x 1200 @ 85 Hz. The highest resolution
available will be determined by the following factors:
■
Memory speed and amount
■
Single or dual channel memory
■
Number and type of monitors
✎
The IGC is designed for optimum performance with multi-sync analog monitors.
Digital displays may not provide an image as high in quality, depending on resolution.

HP Compaq dc7600 MT Specifications

General

Memory	Up to 4 GB DDR2 SDRAM
Audio	Integrated High Definition Audio
Expansion Slots	1 PCI Express x16, 1 PCI Express x1, 2 PCI
Form Factor	Microtower
Processor	Intel Pentium 4 or Intel Celeron D
Chipset	Intel 945G Express
Hard Drive	40 GB to 160GB SATA
Optical Drive	DVD-ROM, DVD+/-RW
Graphics	Integrated Intel Graphics Media Accelerator 950
Networking	Integrated 10/100/1000 Ethernet
Ports	Serial, parallel, VGA, audio in/out
Operating System	Windows XP Professional, Windows XP Home
USB Ports	8 USB 2.0 (2 front, 6 rear)