Service Reference Guide, d300, dx6050 319865-008 8–3
Removal and Replacement Procedures— Desktop (DT) Chassis
8.3 Hood Sensor
1. Prepare the computer for disassembly (Section 8.1, “Preparation for Disassembly”).
2. Remove the computer cover (Section 8.5, “Computer Cover”).
3. Disconnect the hood sensor cable from the system board.
4. Slide the hood sensor switch towards the front of the computer 1 and lower it down through
the slot 2.
To install the hood sensor, reverse the removal procedure.
To Next Page
Loading...
