Service Reference Guide, d300, dx6050 319865-008 8–25
Removal and Replacement Procedures— Desktop (DT) Chassis
8.12 Power Switch Assembly
1. Prepare the computer for disassembly (Section 8.1, “Preparation for Disassembly”).
2. Remove the computer cover (Section 8.5, “Computer Cover”).
3. Remove the 5.25" drives from their bays to gain access to the power switch assembly
(
Section 8.10.2, “Removing a Drive”).
4. Disconnect the power switch/LED cable from the system board.
5. Squeeze the switch holder retaining clips together at the front of the chassis 1 and push the
switch assembly out of the chassis 2.
To install the power switch assembly, reverse the removal procedure.
To Next Page
Loading...
