8–32 319865-008 Service Reference Guide, d300, dx6050
Removal and Replacement Procedures— Desktop (DT) Chassis
8.15.3 Type 3
1. Release the tension from the heatsink 1.
2. Remove the retaining clips 2.
3. Remove the heatsink from atop the processor 3.
4. Open the ZIF socket lever 4.
5. Remove the processor 5.
To install the processor and heatsink:
1. Insert the processor into the ZIF socket.
2. Press down on the processor while rotating and locking the ZIF socket handle in place.
3. Refresh the thermal grease between the heatsink and processor if necessary.
4. Install the heatsink and latch it in place.
5. Connect the heatsink fan control to the system board.
6. Replace the access panel and reconnect the computer.
To Next Page
Loading...
