367187-002.book Page 3 Friday, March 17, 2006 10:38 AM
First-time setup
Set up the computer
To set up the computer, you will
1. Insert the battery pack into the computer.
✎
2. Connect the computer to external power.
The battery pack begins to charge.
3. Turn on the computer.
4. Set up the software.
✎
5. Create recovery discs (recommended).
Refer to Appendix C, “Backup and recovery,” for instructions.
Ä
CAUTION: To prevent file corruption and ensure that the correct drivers
are installed:
■� Do not set up the computer for the first time while the computer is
docked in an optional docking device.
■� During the hardware and software setup procedures:
❏� Do not unplug the computer from external power.
❏� Do not shut down the computer or initiate standby
or
hibernation.
Getting Started� 1–3
To Next Page
Loading...
Need help?
General
