HP CX 6300 - Page 20

HPE Aruba Networking CX 6300 Switch Series | Installation and Getting Started Guide 20
Fan Condition Fan Speed Fan Redundancy Shutdown
2 fans fault N/A Not supported Upon detection, system will be
shut down in 3 minutes or
component hits thermal limit
System with no fan tray
Missing both fan
tray/all fans faulted
N/A Not supported Upon detection, system will be
shut down in 3 minutes or
component hits thermal limit.
Fan redundancy refers to fans and not fan trays. With 2 fan trays installed, it allows 1 fan fault. With 1 fan tray, there is
no fan redundancy.
Fan tray with faulty fan/fans must be replaced with HPEAruba Networking X751 Port to Power Fan Tray (JL669B).
For JL658A, JL659A, JL762A, R8S89A, R8S90A, R8S91A, R8S92A, S0E91A, and S0X44A:
Fan Condition Fan Speed Fan Redundancy Shutdown
4 fans functioning
normally
Accordingly to ambient and
component temperature
N+1 Component hits thermal limit
1 fan fault Remaining fans will spin with
Max speed
Not supported Component hits thermal limit
More than 1 fan
fault
Remaining fans will spin with
Max speed
Not supported Upon detection, system will be
shut down in 3 minutes or
component hits thermal limit.
Missing any fan
tray/all fans faulted
N/A Not supported Upon detection, system will be
shut down in 3 minutes or
component hits thermal limit.
Power supplies
The following power supplies can be installed in the 6300M switches:
n HPEAruba Networking X371 12VDC 250W 100-240VAC Power Supply (JL085A): A 250 watt power supply for
the non-PoE switches. This power supply does not provide any PoE power, and is keyed so that it will not fit into
the power supply slots of HPEAruba Networking PoE switches.
n HPEAruba Networking X371 12VDC 250W 100-240VAC Power-to-Port Power Supply (JL760A): A 250 watt
and back-to-front fan flow power supply for the non-PoE switches. This power supply does not provide any PoE
power and is keyed so that it will not fit into the power supply slots of HPEAruba Networking PoE switches.
JL760A is for use only in the JL762A switch. This is the only power supply available for the JL762A switch.
n HPEAruba Networking X372 54VDC 680W 100-240VAC Power Supply (JL086A): A 680 watt power supply for
applicable PoE switches. Offers up to 370 watts of PoE power, and is keyed so that it will not fit into the power
supply slots of non-PoE HPEAruba Networking switches.
n HPEAruba Networking X372 54VDC 1050W 110-240VAC Power Supply (JL087A): A 1050 watt power supply
for applicable PoE switches. Offers up to 740 watts of PoE power, and is keyed so that it will not fit into the power
supply slots of non-PoE HPEAruba Networking switches.