HP D2D Installation And Configuration Guide

Figure 28 General tab (iSCSI)
NOTE: When you use the Web Management Interface to create an additional device for your
host, you must provide the iSCSI Initiator Name. This is the Initiator Node Name found on the
General tab.
Authentication
If you wish to use mutual authentication (where target authentication is also required), click Secret
on the General tab and enter the appropriate string at the prompt.
NOTE: IPSec Tunnel Mode is not currently supported on HP D2D products.
Figure 29 CHAP secret
The CHAP secret may be between 12 and 16 alphanumeric characters and should be exactly the
same string as you enter on the Web Management interface in the Target CHAP Secret field on
the Devices page on the Web Management Interface. See the HP StoreOnce Backup System user
guide for more information.
iSCSI Initiator (optional, VTL only) 37

HP D2D Specifications

General

Brand	HP
Model	D2D
Category	Storage
Language	English