Removal and replacement procedures 26
3.
Release the I/O handle, push the I/O handle down until it ejects the I/O module, and then remove the
I/O module.
CAUTION: For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component permanently,
replace it with a blank.
To replace the component, reverse the removal procedure. Be sure the I/O module is fully seated and the I/O
module handle is in the locked position.
I/O module blank
CAUTION: For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component permanently,
replace it with a blank.
To Next Page
Loading...
